Damage formula
The game's own help text states the core rule: damage equals penetration minus defense. This page puts that into numbers and shows what changes it. Exact per-ball damage is calculated by the server, so these figures are estimates until calibrated with measured hits.
Per ball
Damage per ball ≈ (cannon penetration + ammo penetration − armor at the impact angle) × ammo damage factor
- The in-game UI shows per-ball damage as (cannon pen + ammo pen − 2.1) × damage factor,
and damage per minute as (pen − 2) × 60 ÷ reload.
- Armor at an angle: a ball striking at an angle meets more armor. Effective armor ≈ armor ÷ cos(angle).
Very flat (glancing) hits do little.
- Some ammo has a minimum damage through any hit zone.
How a hit is detected
A cannonball doesn't have to touch the visible hull. Each frame, the game draws a line from the ball's last position to its new one, and tests that line against three kinds of invisible boxes, in this order:
- The hull box: one box around the hull, from the waterline to the deck. If the line crosses it, it's a hull
hit, even where the curved hull is narrower than the box (near the bow, for example).
- Mast boxes: if the hull box was missed.
- Sail boxes: up to three sails per ball. Each sail slows the ball.
The box can stand in for a curved hull because the game also keeps a table of hull surface directions all the way around the outline: a pointed bow, curved shoulders, flat sides, and a wide flat stern. Where the ball meets the box tells the game which part of the hull it struck and how steeply. That's what makes angling, bow and stern matter.
Where you hit
- Bow: the sturdiest part of the ship; hits there do less.
- Stern: protection is much lower, so hits do more. A stern hit on a
ship that is already sinking finishes it instantly.
- Side: normal armor.
- Masts and sails: balls passing through sails damage them and lose energy
(after one sail a ball keeps 1/2 its energy, after two 1/3, and it stops after three).
Overpenetration
Ammo with overpenetration (Saxon shot) can pass through the first ship and hit another behind it with reduced energy.
Modifiers
| Effect | What it does |
|---|---|
| Armor bonus (PArmor / MArmor) | Raises armor |
| Ball damage (PBallDamage) | Multiplies ball damage |
| Weapon penetration (MWeaponPenetration) | Adds penetration |
| Damage reduction (PReduceDamage) | Cuts incoming damage, capped at 99% |
| Bow damage reduction (PReduceDamageToNose) | Extra reduction for bow hits |
| Long-range damage (PBallDamageWhenMaxDistance) | More damage at maximum range |
All bonuses from upgrades, crew, skills and items add together.
Targeting hint
The game warns you when the target's armor is above 40% of your average penetration: a sign that your guns will do little.
Damage formula calibration
The server, not the client, decides how much HP a cannonball removes (penetration against armor, range, angle, crits). To reproduce it, record hits with known inputs and fit a model.
What to record per shot
- shooter ship, cannon type, ammo, target ship
- range (and angle if possible)
- target HP before and after the hit (from the HP bar or video)
- where it hit: hull, sail, stern, bow
How to record it
- Start a Gameplay Capture session; set shooter, target, weapon and ammo.
- Use the hotkeys to mark broadside, single shot, hit, miss, stern, side, bow.
- Afterwards, read the HP values off the clips and enter them in the trial sheet.
- 10–20 clean single-shot hits per cannon/ammo pair is enough for a first fit.
Hull and sail behaviour after the hit is already exact — see Damage and sinking.